[. . . ] · Double Tamper protection: When the siren front panel is removed or when the siren is removed from the wall, tamper alarm is sent to the alarm system. · 2-way full supervision The siren is a fully supervised, 2-way communication device. It includes a receiver, to receive event messages from the alarm system, and a transmitter, to periodically transmit its status signal to the alarm system. Self-test feature Fig. [. . . ] Battery cable Figure 3: Battery Pack Insertion 3. 3 Cover Closure See Figure 4. 1. Secure with screw. 1 G C F 2 D E Figure 4 - Cover Closure 4. ENROLLMENT Refer to the control panel Installer Guide for the device enrollment procedure. 2 D-303089 5. SR-720 PG2 DEVICE SETTINGS This section describes how to configure the parameters of the siren from the control panel. To Modify the Siren Device Settings Refer to the control panel Installer Guide and perform the procedure for Adding A Wireless Device (section 4. 5. 2), or, Modifying a Device (section 4. 5. 5). STROBE ALARM Here you determine whether or not to activate the strobe alarm, and if to activate whether to activate the strobe until the alarm system is disarmed, or, for the programmed period of time (see section "Siren Configuration" in the control panel Installer Guide). 2. AUTO TAMPER ALRM When exiting "INSTALLLER MODE" menu, the alarm system displays the number of devices that need to be updated, as follows: "DEV UPDATING NNN". For detailed instructions on Adding Devices, Deleting Devices, Replacing Devices and Defining Defaults see the control panel Installer Guide. Here you determine whether or not the siren alone will sound a tamper alarm when there is no communication between the siren and the control panel. or Select between "Volume HIGH", "Volume LOW" and "Volume MID". or Select between "Disabled", "Sounder only", "Strobe only" and "Sounder+strobe". Here you determine whether or not to activate the squawk, and if enabled, whether to activate the sounder only, or, the sounder and strobe simultaneously. or Select between "Disabled", "Disabled & Home" and "Enabled". Here you determine whether or not to activate the exit ­ entry beeps, and if enabled, whether to activate in HOME or AWAY mode. [. . . ] The Manufacturers obligations under this Warranty are limited solely to repair and/or replace at the Manufacturer's discretion any Product or part thereof that may prove defective. Any repair and/or replacement shall not extend the original Warranty period. The Manufacturer shall not be responsible for dismantling and/or reinstallation costs. [. . . ]